It’s been awhile since I’ve built a new Quad so when I saw this frame on MyRcMart I just had to pick it up, I’ve always wanted to try out one of the smaller quads and this one definitely is small. I found it to be a much harder build since everything is so compact […]

This is my 2nd ZMR250 build, with this one I decided to try the Diatone ZMR250 Power Distribution Board Ver1 (Ver 2.1 has issues) so I can use both 3s and 4s Lipo’s and DYS SN20a Opto Esc using the PDB to power the flight controller as well as handling the voltage requirement for my […]

Make sure you flashed the latest version of OpenTX on your Taranis and start the Companion app. Let’s create a new model and start with the Setup screen. This is all very standard with a timer that triggers when Throttle is not at 0 and gives out voice alert every minute. I also like center […]

This will be a walk thru setting up Cleanflight on a Flip32 (similar to a Naze32 board) using the standard FrSky D4R-II Receiver flashed with the 27ms firmware and a Micro MinimOSD board running MW OSD with a RTFPIXEL STICK. Start by downloading the latest Cleanflight Configurator, you will need Google Chrome installed on your computer. Flash […]

Well the good weather is finally here and I spent most of it flying my ZMR250 maybe a little to hard as now I have to rebuild it after a particularly hard crash on the pavement. Total damage all the plastic screws broke, will be replacing them with steel,sma connector on the TX ripped out […]