Finally installed airmode on my 250 and took it out for a flight this afternoon. I have to say its AWESOME running stock pids its very locked in but I got a little carried away and bounced it off a tree, tree won 🙂 Total damage 2 motors & props and no video 🙁 […]
Read More →I’ve been trying for a while to figure out how to get RSSI to properly display on my OSD using MW OSD and a D4R-II receiver through my Flip32 (this works for a true Naze32 as well). After trying several different solutions, I read a post on how to inject the RSSI signal into the ppm stream to […]
Read More →This is my 2nd ZMR250 build, with this one I decided to try the Diatone ZMR250 Power Distribution Board Ver1 (Ver 2.1 has issues) so I can use both 3s and 4s Lipo’s and DYS SN20a Opto Esc using the PDB to power the flight controller as well as handling the voltage requirement for my […]
Read More →After 4 years of use the box I use to run my blog as well as serve files and backup my computers died two weeks ago. It took a day to figure out the motherboard had failed & two more days of research to decide to replace it with a Synology DS415+. I purchased […]
Read More →After visiting the RV show yesterday we ventured out to visit a few RV dealers to check out some floor plans and models that weren’t at the RV show. First stop was Johnson RV in Sandy OR. huge lot which held more RV’s at this one dealer than we have at all the dealers near us. […]
Read More →Spent the day at the Portland Fall RV Show checking out all the new and used Motorhomes. Found it to be very helpful in narrowing down our choices for when we purchase a Motorhome in the early part of 2017. We were at the show for over 8 hours and walked over 12km moving thru the […]
Read More →Our search for the perfect RV has finally started. Sitting in the BlackBall ferry line to begin the start of our short trip to Portland to see the Northwest RV show. Really looking forward to finally checking out all the RV’s I have researched online.
Read More →My boss asked me last week if I thought I might be able to fix his laptop, the power jack had been damaged and needed to be replaced. I like to dabble with electronics and after checking out a few videos on YouTube it looked like it might be possibe. I ordered a replacement jack […]
Read More →Went up to Bear Mountain this afternoon to attend the BearTrax Festival had an awesome time watching the riders leap 20 meters and more on the their bikes while doing flips and tail wags. It was very impressive to see in real life much more interesting than watching it on the telly. It was a […]
Read More →Went down to the buskers festival this evening and thoroughly enjoyed the entertainment put on by the performers, way more entertaining than a movie and cost much less. https://dl.dropboxusercontent.com/u/28944667/Photos/Busker1.mp4
Read More →