It’s been awhile since I’ve built a new Quad so when I saw this frame on MyRcMart I just had to pick it up, I’ve always wanted to try out one of the smaller quads and this one definitely is small. I found it to be a much harder build since everything is so compact but the end results are pretty good. If I had spent a little more time on the wiring it would have been great but after working on it for a week I just wanted to fly it.  😉

One of the downsides to this size is the lack of space so there will be no HD video from this little guy, the 1300Mah lipo I am using takes up the entire top plate so until I can figure out how to mount my Mobius  on it all video will be downlink only.

Maiden Flight

 

Quad Build Specs:
Quad Frame: RCX H175CF FPV Racer
Flight Controller: Flip32 +
Motors: RCX H1806-6 2400KV motors  Req  (M2X6 Cap Screws)
ESC’s: DYS SN20A-Mini 20A esc flashed with BL Heli
Power Distribution Board: Mini Power Distribution Board
Props: Dal Props 4045BN & Tri T4045BN Bullnose
Batteries:  Old 1300 Mah might try 4s

 

Controller Set up:
Flight Receiver: FrSky D4R-II
Flight Controller: Frsky Taranis
TX Module: Built in

FPV Set up:
FPV Camera: Foxeer XAT600M 600tvl Sony Super Had
Video Recording: Downlink
Video TX: RCX TS5823 5.8GHz 32CH Mini FPV Video Transmitter (200mW)
Video RX: Skyzone FPV Goggles 5.8GHz Dual Diversity 32CH Receiver With Head-Tracker
Antennas: AOMWAY 5.8G 3dBi Four Lobe RHCP VTx/VRx Antenna Multimotor RPSMA

 

Kit Contents

Motors & Esc’s

Flight Controller

Ready to Fly